municipal utility

City of College Station Backflow Prevention backflow testing requirements

College Station is a useful procedural page because it clearly publishes the tester list, report form, 30-day submission rule, and City registration requirements for BPATs.

Use this page to confirm the governing rule, then open the focused page that matches your exact situation.

Testing cadence: Installation testing plus ordinance-driven ongoing reporting Last verified: 2026-06-29 Verification code: TL Freshness window: 45 days
Next-step paths

Start with the page that matches your situation

This page is the rule hub. Use it to confirm the governing utility workflow, then open the focused page that matches the actual situation on site.

Routine notice

Annual testing

Open the annual page when the utility notice is about routine testing, timing, and accepted submission methods.

Urgent status

Failed test

Open the failed-test page when the device already failed and you need the repair, retest, and reporting order.

System-specific

Irrigation

Open the irrigation page when the question is tied to sprinkler systems, reclaimed water, or landscape devices.

System-specific

Fire line

Open the fire-line page when the backflow assembly serves fire protection equipment or a managed commercial site.

Provider route

View the official tester list

Use the published tester route after you confirm the rule, due basis, and submission path on this utility page.

Testing cadence

Annual or event-based timing

Lawn irrigation systems, properties where inspectors require a backflow assembly, and fireline or general assemblies using City-registered testers.

  • Installation testing plus ordinance-driven ongoing reporting
  • College Station says backflow prevention devices must be tested on installation, testers must be TCEQ-certified and registered with the City, and original reports must reach Water Services within 30 days of testing per city ordinance.
Penalty exposure

Non-compliance penalties

College Station requires tester registration with the City and says original reports must reach Water Services within 30 days of testing. Tester registration also carries a $50 annual company fee.

  • College Station separates state certification from City registration; both matter.
  • The report deadline is tied to when testing occurs, not just when a notice is received.
  • Irrigation work adds a permit requirement on top of the testing workflow.
Compliance workflow

Official workflow

Every focused page on this utility still runs through this authority sequence. Confirm the rule here before you branch into repair, testing, or provider routing.

  1. Confirm whether the project or property requires a backflow assembly through Water Services or the irrigation permit workflow.
  2. Use a TCEQ-certified BPAT who is also registered with the City of College Station.
  3. Complete the City report form and deliver the original report to Water Services within 30 days of testing.
  4. If you need a tester, start with the City's registered tester PDF rather than a generic search.
Source block

Source block

College Station is strong on source-backed process: install-test requirement, city-registered BPATs, a published tester list, a report form, and a 30-day report delivery rule tied to ordinance.

Covered property types

Where the rule applies

  • Lawn irrigation systems requiring a permit and approved backflow device
  • Properties where a certified inspector deems a backflow assembly appropriate
  • Sites requiring general or fireline registered testers
Covered device types

Devices in scope

  • Backflow prevention assemblies
  • Irrigation backflow devices
  • Fireline and general assemblies represented on the City's tester list
Residential notes

Residential notes

  • Residential users most often see College Station through irrigation permit work and required installation testing.
  • City registration still matters on the tester side even when the property is smaller.
Commercial focus

Commercial and managed properties

  • Commercial and managed properties should pay attention to the separate fireline and general tester categories on the City list.
  • The report deadline and company registration fee make College Station more process-heavy than a generic plumber explanation suggests.
FAQ

Local questions people actually ask

Does City of College Station Backflow Prevention require annual backflow testing?

Installation testing plus ordinance-driven ongoing reporting. College Station says backflow prevention devices must be tested on installation, testers must be TCEQ-certified and registered with the City, and original reports must reach Water Services within 30 days of testing per city ordinance.

Who is affected by City of College Station Backflow Prevention backflow rules?

Lawn irrigation systems, properties where inspectors require a backflow assembly, and fireline or general assemblies using City-registered testers.

How do I submit or confirm a backflow test for City of College Station Backflow Prevention?

Use the official utility workflow and submission methods listed on this page: College Station drinking water and backflow page, College Station registered tester list, College Station backflow test report. Program phone: 979-764-3660.

Where should I look for testers for City of College Station Backflow Prevention?

Start with the governing authority's published tester list. This utility has an official approved-tester route and it should be treated as the primary source.

After the rule is clear

Need a tester or local help?

Start with the governing authority's published tester list. Use provider help only after the official rule, due basis, and submission path are clear.

Market cost analysis

Local cost band

Typical testing and repair pricing used to frame next-action decisions in the metro around this utility.

The published $50 annual registration fee applies to tester companies, not directly to the property owner.

Provider browse layer

Public provider direction

Provider routing stays clearly labeled below the official workflow. This block exists to frame public provider discovery without implying authority status.

Backflow technician inspecting an industrial assembly
Local testing profiles Use provider profiles and metro pages only after confirming the utility workflow and list rules above.
Pressure vacuum breaker on an exterior wall
Public directory stays separate Provider help is reviewed separately from the official utility workflow and never replaces the authority guidance above.